NEVER ALLOW ANY ALTERATION OR REPLACEMENT OF PARTS IN YOUR FIREARM UNLESS PERFORMED BY A QUALIFIED GUNSMITH USING AUTHORIZED PARTS. Improper manipulation of any other internal component may affect the safety and reliability of your firearm and may cause serious injury or death. Grips that have been modified in any way ARE NOT RETURNABLE.Īfter installing grips, CHECK YOUR GUN and make sure that all parts of the gun function correctly and without being obstructed or hindered by the grip. Also bear in mind the instruction by manufacturer of your wepon. Please, read the instructions and DO NOT attempt any alteration until you have done so. Even then, grips are not always a perfect fit right out of the package.
FN 1905 GRIPS WG3 INSTALL
IMPORTANT NOTE: Only install grips on the frame for which they were designed. Carefully separate these grip panels to avoid breakage. and probably was designed to fasten the grip of the ruling imperial dynasty on the. If the grips do not fit correctly, DO NOT FORCE THEM ON.Ĭertain grips appear to be a one piece grip, but are in effect 2 pieces pinned together. If new screws are supplied with the grips, use them. Please, refer to the instruction for each particular grip on the web page relating to that grip.Ĭlean the frame before installing new grips. Set aside and preserve the factory grips, as they might be a valuable part of the weapon and should you decide to sell the weapon they could increase the value. Be careful not to damage the existing grips.
Remove Existing Grips as per the instructions of the manufacturer. Double check to make sure no rounds remain in the weapon. Revolvers: Open the cylinder and remove any rounds. I know the model 10 is basically the same gun but the tops of the grips look different. I plan on keeping the originals but they are in rough condition and would like some new ones for shooting. Pistols: Remove the magazine, clear the action and check barrel and chamber to ensure they are clear of any rounds. Hi guys, I recently bought a 1922 S&W M&P model of 1905 4th change revolver an am having a hard time finding replacement grips for it. Point the gun in a safe direction to unload it.
Before any manipulation wiht the gun MAKE SURE it is UNLOADED.